STEP 1 – INTO THE TRUCK
When using the integral coloring system, the first step is to put the colorant into the truck. We recommend using a 4-inch slump. When adding the Uni-Mix®, make sure you have brought the load to the top of the truck. Simply tear off the the top of the bag, and throw in the entire bag, including the packaging. This saves a lot of mess, and the bag disintegrates completely. Mix for 110 revolutions.
STEP 2 – POURING
This is a fairly standard procedure. After the truck has mixed for approximately 110 revolutions (about 5 minutes), pour the concrete.
STEP 3 – STRIKING OFF
The initial leveling off of the concrete is called striking off, and is shown here using a straight 2 x 4.
STEP 4 – JITTERBUGGING
The process known as “jitterbugging” helps bring some of the cream to the surface, allowing smoother finishing and stamping.
STEP 5 – BULLFLOATING
“Bullfloating” is the next step. This closes the surface, bringing cream to the surface while flattening and smoothing it. It uses a long-handled magnesium float.
STEP 6 – EDGING & TROWELLING
Edging the concrete gives it a nice smooth radius edge to the concrete.
STEP 7 – THE FRESNO FINISH
The Fresno is the final finishing before release is applied. It uses a long-handled trowel, which is made of steel.
Note: The use of the fresno should be avoided if freeze thaw is an issue. Instead, the final finish should be performed with a wood or magnesium bullfloat.
STEP 8 – THROWING RELEASE
Once satisfied with the edging and the finish, it is time to throw the release
As you can see, the release is spread evenly over the entire slab of concrete by literally throwing it. The release agent is used to prevent bonding between the stamping tools and the concrete. It also adds depth and texture to the concrete.
STEP 9 – LAYING THESTAMPS
The Largestone Fan pattern is being used here, and as you can see, laying the stamps starts on one side of the job, and works its way over to the other side.
This is a continuation of the laying process.
STEP 10 – FINALLY, THE STAMPING!
To help imprint the stamps, we use a 10″ x10″ cast iron tamper with a strong wood handle.
On the right, you’ll notice that flexible mats are being used along the edges to extend the pattern fully.
STEP 11 – FINISHING TOUCHES
It may be necessary to touch up some of the joints using a chisel before the concrete has dried.
STEP 12 – THE END PRODUCT
After 1-2 days, or when concrete has cured sufficiently, it should be pressure washed to remove excess release powder. After the concrete has dried thoroughly, it should be sealed using our non-yellowing acrylic sealer.
Here is the patio from the other side.
Information for this post was provided by Butterfield Color.